The Rotomolding Machine is ideally suited for the manufacture of hollow products.

The product edge strength of the Rotomolding Machine is good - rotomolding can achieve a thickness of more than 5 mm at the edge of the product, which completely solves the problem of the thin edge of the hollow product.

The concept of Rotomolding Machine is a simple one, but in reality, it is challenging for some manufacturers to get a good product from the process. Rotomolding is valued for its advantages over other molding methods.

When using the Rotomolding Machine, the lubricated parts should be cleaned and the plastic compatibility test should be done.

The rotational moulding machine is a relatively large product, the plastic pellets are put into the mould and heated, and then the mould is constantly rolled to make the plastic fit the inner wall of the mould. The moulds are cheap and the products are expensive. They mainly produce hollow, packaging and oversized products with a large shrinkage ratio and low output.